The short version of intranasal delivery fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2026-08-01. Anything still debated is marked as such rather than presented as settled.
Published studies examine a fairly narrow set of endpoints. Rodent experiments commonly measure maze learning, infarct volume after induced ischemia, and tissue levels of neurotrophic factors. Clinical reports from Russian centres describe attention, memory and recovery scores in patients after stroke or transient ischemic attack. Most of those human studies are small and few have been repeated by independent groups. Outcome measures differ between studies, which limits direct comparison.
Circulation time for the peptide is short because peptidases cleave it readily. The Pro-Gly-Pro tail is thought to slow breakdown compared with the bare ACTH fragment, but the gain appears modest. Absorption after intranasal dosing is limited, and only a fraction of a dose is expected to reach the central nervous system. Laboratory concentrations therefore sit well above levels achieved systemically, a gap that complicates translation from bench findings to clinical claims.
The mechanisms attributed to semax are inferred from animal and cell studies rather than traced to one confirmed target. The most frequently cited pathway involves increased expression of brain-derived neurotrophic factor and nerve growth factor in hippocampal and cortical tissue. Some work points to engagement of melanocortin receptors, particularly MC4, which the parent ACTH fragment can activate. Effects on dopaminergic and serotonergic signalling have also been reported. No single account explains all observed results, and the relative weight of each pathway remains unsettled.
Identity and purity of semax are established with reversed-phase high-performance liquid chromatography coupled to ultraviolet detection, usually at 214 nanometres. Mass spectrometry, most often electrospray ionisation in positive mode, confirms the molecular mass and reveals truncated sequences. Amino acid analysis and peptide mapping after enzymatic digestion provide additional structural confirmation. Laboratories typically report purity as the percentage area of the main peak, a figure that does not capture isomeric or oxidised variants unless the method resolves them.
The peptide is prone to several degradation pathways. Oxidation of the methionine residue produces a sulfoxide that elutes close to the parent peak in many chromatographic systems. Hydrolysis of peptide bonds and deamidation of susceptible residues in related sequences also reduce purity over time. Lyophilised material kept dry at minus twenty degrees Celsius and shielded from light is the most stable form commonly described in laboratory practice.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilized solid from research suppliers |
| Solubility | Freely soluble in water | Also dissolves in aqueous buffers; solutions are used fresh |
| Typical storage temperature | -20 °C for lyophilized powder | Short-term transport at 2-8 °C is common |
| Common analytical method | Reverse-phase HPLC | Paired with mass spectrometry for identity confirmation |
| Common synonyms | ACTH(4-10) analogue; MEHFPGP | N-terminal methionine retained in the chain |
Stability depends heavily on physical state. Lyophilized powder held dry, cold and dark retains its content over long periods, whereas dissolved peptide begins to change within days at room temperature. The most cited degradation route is oxidation of the methionine residue, which converts the peptide to a sulfoxide form that elutes differently on chromatography. Hydrolysis of amide bonds and adsorption onto container walls contribute smaller losses. Buffers that exclude oxygen from the headspace slow the oxidation pathway, but no single condition prevents all change indefinitely.
Practical handling follows from those properties. Bulk material is best divided into single-use portions soon after receipt, because each thaw exposes the whole container to moisture and temperature cycling. Vials should be allowed to reach room temperature before opening to prevent condensation on the powder. Low-binding plasticware reduces loss of dilute solutions, and sterile filtration is used when a preparation must remain free of microbial growth. Records of batch number, reconstitution date and storage history are what allow a later analytical result to be interpreted meaningfully.
Identity and purity of Semax are established mainly by reversed-phase high-performance liquid chromatography coupled with mass spectrometry. The chromatographic trace gives a purity estimate as a percentage of total peak area, while electrospray or matrix-assisted laser desorption ionization confirms the molecular mass against the calculated value. Amino acid analysis and sequence-specific fragmentation provide further confirmation when a supplier's chain of custody is unclear. Vendors frequently quote a purity figure without stating the detection wavelength or the integration method, which limits how far one number can be compared with another.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Identity and purity are established with standard peptide methods. Reversed-phase HPLC with ultraviolet detection near 214 nm resolves the parent peak from deletion and truncation byproducts, and reports typically quote a main-peak percentage. Mass spectrometry by electrospray or MALDI-TOF confirms the expected molecular mass, while amino acid analysis or peptide mapping can verify composition when the sequence itself is in question. A certificate of analysis that pairs a chromatogram with a mass spectrum is more informative than a purity figure alone. Counter-ion content and residual solvents are separate specifications and are frequently omitted.
A cytocentrifuge, sometimes referred to as a cytospin, is a specialized centrifuge used to concentrate cells in fluid specimens onto a microscope slide so that they can be stained and examined. Cytocentrifuges are used in various areas of the clinical laboratory, such as cytopathology, hematology and microbiology, as well as in biological research. The method can be used on many different types of specimens, including fine needle aspirates, cerebrospinal fluid, serous and synovial fluid, and urine.
== Novel antidepressant == Arketamine appears to be more effective as a rapid-acting antidepressant than esketamine in preclinical research. In rodent studies, esketamine produced hyperlocomotion, prepulse inhibition deficits, and rewarding effects, while arketamine did not, in accordance with its lower potency as an NMDA receptor antagonist and dopamine reuptake inhibitor. As such, arketamine may have a lower propensity for producing psychotomimetic effects and a lower abuse potential in addition to superior antidepressant efficacy. A study conducted in mice found that ketamine's antidepressant activity is not caused by ketamine inhibiting NMDAR, but rather by sustained activation of a different glutamate receptor, the AMPA receptor, by a metabolite, (2R,6R)-hydroxynorketamine; as of 2017 it was unknown if this was happening in humans. Arketamine is an AMPA receptor agonist. Paradoxically, arketamine shows greater and longer-lasting rapid antidepressant effects in animal models of depression relative to esketamine. It has been suggested that this may be due to the possibility of different activities of arketamine and esketamine and their respective metabolites at the α7-nicotinic receptor, as norketamine and hydroxynorketamine are potent antagonists of this receptor and markers of potential rapid antidepressant effects (specifically, increased mammalian target of rapamycin function) correlate closely with their affinity for it. The picture is unclear however, and other mechanisms have also been implicated.
=== Pharmacodynamics === MDDMA shows reduced potency as a monoamine releasing agent and reuptake inhibitor compared to MDA and MDMA. It was 11-fold less potent than MDMA and 4-fold less potent than MDA as a serotonin releasing agent (SRA). Moreover, whereas MDA and MDMA are serotonin–norepinephrine–dopamine releasing agents (SNDRAs), MDDMA is a selective SRA along with ≥10-fold weaker dopamine and norepinephrine reuptake inhibition. The related drug MDTMA is completely inactive as a monoamine releasing agent, though it does still show very weak monoamine reuptake inhibition. Another related drug, dimethylamphetamine, is said to be a prodrug of methamphetamine and amphetamine, although it is much less potent and weaker than these drugs. (R)-MDDMA has been found be inactive as a serotonin releasing agent but to act as a partial agonist of the serotonin 5-HT2A and 5-HT2C receptors. Conversely, unlike MDMA, it was inactive as a serotonin 5-HT2B receptor agonist. In animal studies, (R)-MDDMA did not produce the head-twitch response, affect body temperature, or induce hyperlocomotion, and showed diminished or no prosocial effects. On the other hand, it produced psychoplastogenic effects mediated by serotonin 5-HT2 receptor activation as well as promoted fear extinction and induced antidepressant-like effects. It was concluded that (R)-MDDMA is a non-hallucinogenic psychoplastogen with improved safety compared to MDMA and (R)-MDMA.
Sources: en.wikipedia.org
Ribosomal RNA (rRNA) contains highly conserved secondary structural elements that are shared across diverse species, indicating that these sequences are among the most ancient and evolutionarily conserved components of living organisms. rRNA plays a fundamental role in protein synthesis by forming the structural and catalytic core of the ribosome. During translation, rRNA facilitates the interaction between messenger RNA (mRNA) and transfer RNA (tRNA), ensuring accurate decoding of the genetic code into amino acid sequences. Within the small ribosomal subunit (SSU), rRNA binds the mRNA and aligns it with the anticodon of the tRNA. In the large ribosomal subunit (LSU), rRNA interacts with the amino acid acceptor end of the tRNA and catalyzes peptide bond formation, transferring the growing polypeptide chain from one tRNA to the next. This catalytic activity is mediated by specific rRNA stem-loop structures that create functional binding regions within the ribosome. The ribosome contains three major tRNA-binding sites: the aminoacyl (A) site, where incoming charged tRNAs bind; the peptidyl (P) site, which holds the tRNA carrying the growing polypeptide chain; and the exit (E) site, through which uncharged tRNAs leave the ribosome after peptide transfer:
Liquid chromatography: Traditional chromatography columns were made of glass. Modern columns are mostly made of borosilicate glass, acrylic glass or stainless steel. To prevent the stationary phase from leaking out of the column interior a polymer, stainless steel or ceramic net is usually applied. Depending on the application material- and size-requirements may change. Gas chromatography (GC): Older columns were made of glass or metal packed with particles of a solid stationary phase. More recently, narrower diameter (capillary) columns have been made using fused silica coated on the inside with a film of the stationary phase material. GC columns are typically very long to take advantage of their low resistance to the flow of carrier gas. The materials of the column and the stationary phase must be suitable for GC operating temperatures, which may range as high as 300°C or more.
Gemini 4's crew originally intended to call their spacecraft American Eagle, but this was rejected after NASA management issued a memo saying that they did not want a repeat performance of the previous mission, on which Gus Grissom had named his spacecraft Molly Brown. The callsign for the mission became simply Gemini 4. There was no patch flown on the crew's suits, although the one shown here was created after the mission and is on display in McDivitt's museum. Since McDivitt and White were prohibited from naming their spacecraft, they decided to put the American flag on their suits, the first astronauts to do so, although Soviet crews wore the Cyrillic "СССР" on their spacesuit helmets. Previous astronauts had only had the NASA insignia and a strip with their name on their suits.
A clinical trial design in which neither the participating individuals nor the study staff knows which participants are receiving the experimental drug and which are receiving a placebo (or another therapy). Double-blind trials are thought to produce objective results, since the expectations of the doctor and the participant about the experimental drug do not affect the outcome; also called double-masked study. (NLM) A clinical trial in which neither the medical staff nor the person knows which of several possible therapies the person is receiving. (NCI) Double-dummy
Sources: en.wikipedia.org
It consists mainly of animal experiments and small clinical reports, with much of the clinical material published in Russian-language journals. Large independent trials are scarce. Separating reliable effects from chance findings is consequently difficult.
A fraction of an intranasal dose is thought to reach the central nervous system, and this route is favoured partly for that reason. The proportion is not well characterized. Direct measurement in humans remains difficult with current methods.
Raised BDNF and NGF expression has been reported across several animal studies, which makes the signal fairly consistent. Whether the same change occurs in humans at usable doses is not established. It is best treated as a working hypothesis rather than a confirmed clinical mechanism.
Reversed-phase high-performance liquid chromatography is the standard method, with detection in the ultraviolet range. Peak area percentage yields a purity figure for the main component. Mass spectrometry is normally run alongside to confirm molecular identity.